Dmitry Torokhov authored Mar 24, 2016 and Linus Walleij committed Apr 08, 2016

When firmware does not use _DSD properties that allow properly name GPIO
resources, the kernel falls back on parsing _CRS resources, and will
return entries described as GpioInt() as general purpose GPIOs even
though they are meant to be used simply as interrupt sources for the
device:

Device (ETSA)
{
	Name (_HID, "ELAN0001")
	...

	Method(_CRS, 0x0, NotSerialized)
	{
		Name(BUF0,ResourceTemplate ()
		{
			I2CSerialBus(
				0x10,                     /* SlaveAddress */
				ControllerInitiated,      /* SlaveMode */
				400000,                   /* ConnectionSpeed */
				AddressingMode7Bit,       /* AddressingMode */
				"\\_SB.I2C1",             /* ResourceSource */
			)
			GpioInt (Edge, ActiveLow, ExclusiveAndWake, PullNone,,
				 "\\_SB.GPSW") { BOARD_TOUCH_GPIO_INDEX }
		} )
		Return (BUF0)
	}
...
}

This gives troubles with drivers such as Elan Touchscreen driver
(elants_i2c) that uses devm_gpiod_get to look up "reset" GPIO line and
decide whether the driver is responsible for powering up and resetting
the device, or firmware is. In the above case the lookup succeeds, we
map GPIO as output and later fail to request client->irq interrupt that
is mapped to the same GPIO.

Let's ignore resources described as GpioInt() while parsing _CRS when
requesting output GPIOs (but allow them when requesting GPIOD_ASIS or
GPIOD_IN as some drivers, such as i2c-hid, do request GPIO as input and
then map it to interrupt with gpiod_to_irq).

Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Dmitry Torokhov <dtor@chromium.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>