- Feb 07, 2009
-
-
Marcel Holtmann authored
-
Marcel Holtmann authored
-
- Feb 06, 2009
-
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
- Feb 05, 2009
-
-
Marcel Holtmann authored
-
Johan Hedberg authored
This callback is not needed since the same information is communicated as part of the Service Level Connection setup procedure anyway.
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
-
- Feb 04, 2009
-
-
Johan Hedberg authored
-
Johan Hedberg authored
We should not store the link key if either side had "no bonding" as their authentication requirement.
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Johan Hedberg authored
This refactoring is preparation for more fine-grained link key writing control with e.g. SSP "no bonding" use cases.
-
Johan Hedberg authored
We should check HF and not AG features when determining whether the SLC creation is complete or not.
-
Marcel Holtmann authored
-
Marcel Holtmann authored
-
Johan Hedberg authored
-
Marcel Holtmann authored
-
Johan Hedberg authored
The audio profile coexistence whitepaper recommends that the initiator of the A2DP connection also initiates the AVRCP connection. This patch adds a two second delay before we attempt connecting AVRCP after the remote device has connected A2DP to us.
-
Johan Hedberg authored
-
- Feb 03, 2009
-
-
Johan Hedberg authored
-
Johan Hedberg authored
When we are the acceptors of a pairing request and we have used the Agent.DisplayPasskey we need to use the Simple Pairing Complete HCI event for calling Agent.Cancel.
-
Johan Hedberg authored
This patch makes sure that we don't reply to the authentiction requests if we get disconnected before authentication has completed.
-
Johan Hedberg authored
Some headsets when acting as initiators of an AVDTP connection create the AVDTP signaling channel but don't do anything else over it (i.e. they expect us to set up a stream when needed). This patch makes bluetoothd do the same as AudioSink.Connect() if no AVDTP commands have been received from the sink within one second after it has created the AVDTP signaling channel to us. Setting up a stream is also important because the AudioSink Connected property is bound to the existence of a configured stream (which makes sense since an AVDTP connection as such tells us nothing about what sinks and sources there are or even if audio or video will be used).
-
Johan Hedberg authored
-
Marcel Holtmann authored
-
- Feb 02, 2009
-
-
Johan Hedberg authored
-
Johan Hedberg authored
-
Marcel Holtmann authored
-