In jadard_prepare() a reset pulse is generated with the following
statements (delays ommited for clarity):

    gpiod_set_value(jadard->reset, 1); --> Deassert reset
    gpiod_set_value(jadard->reset, 0); --> Assert reset for 10ms
    gpiod_set_value(jadard->reset, 1); --> Deassert reset

However, specifying second argument of "0" to gpiod_set_value() means to
deassert the GPIO, and "1" means to assert it. If the reset signal is
defined as GPIO_ACTIVE_LOW in the DTS, the above statements will
incorrectly generate the reset pulse (inverted) and leave it asserted
(LOW) at the end of jadard_prepare().

Fix reset behavior by inverting gpiod_set_value() second argument
in jadard_prepare(). Also modify second argument to devm_gpiod_get()
in jadard_dsi_probe() to assert the reset when probing.

Do not modify it in jadard_unprepare() as it is already properly
asserted with "1", which seems to be the intended behavior.

Fixes: 6b818c53 ("drm: panel: Add Jadard JD9365DA-H3 DSI panel")
Cc: stable@vger.kernel.org
Signed-off-by: Hugo Villeneuve <hvilleneuve@dimonoff.com>
Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20240927135306.857617-1-hugo@hugovil.com


Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20240927135306.857617-1-hugo@hugovil.com