drm/amd/display: Add support for disconnected eDP streams

[Why]
eDP may not be connected to the GPU on driver start causing
fail enumeration.

[How]
Move the virtual signal type check before the eDP connector
signal check.

Reviewed-by: Wenjing Liu <wenjing.liu@amd.com>
Signed-off-by: Harry VanZyllDeJong <hvanzyll@amd.com>
Signed-off-by: Roman Li <roman.li@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c

@@ -945,6 +945,9 @@ bool link_decide_link_settings(struct dc_stream_state *stream,
 		 * TODO: add MST specific link training routine
 		 */
 		decide_mst_link_settings(link, link_setting);
+	} else if (stream->signal == SIGNAL_TYPE_VIRTUAL) {
+		link_setting->lane_count = LANE_COUNT_FOUR;
+		link_setting->link_rate = LINK_RATE_HIGH3;
 	} else if (link->connector_signal == SIGNAL_TYPE_EDP) {
 		/* enable edp link optimization for DSC eDP case */
 		if (stream->timing.flags.DSC) {
@@ -967,9 +970,6 @@ bool link_decide_link_settings(struct dc_stream_state *stream,
 		} else {
 			edp_decide_link_settings(link, link_setting, req_bw);
 		}
-	} else if (stream->signal == SIGNAL_TYPE_VIRTUAL) {
-		link_setting->lane_count = LANE_COUNT_FOUR;
-		link_setting->link_rate = LINK_RATE_HIGH3;
 	} else {
 		decide_dp_link_settings(link, link_setting, req_bw);
 	}