Commit 7970cb77 authored by Heiko Stuebner's avatar Heiko Stuebner Committed by Linus Walleij

pinctrl: add pinconf-generic define for a pin-default pull

There exist controllers that don't support to set the pull to up or down
separately but instead automatically set the pull direction based on
embedded knowledge inside the controller, for example depending on the
selected mux function of the pin.

Therefore this patch adds another config option to use this default
pull-state for a pin where it is not possible to know or decide if the
pin will be pulled up or down.
Signed-off-by: Heiko Stuebner's avatarHeiko Stuebner <heiko@sntech.de>
Reviewed-by: default avatarStephen Warren <swarren@nvidia.com>
Signed-off-by: Linus Walleij's avatarLinus Walleij <linus.walleij@linaro.org>
parent 78bafc66
......@@ -40,6 +40,8 @@ static struct pin_config_item conf_items[] = {
PCONFDUMP(PIN_CONFIG_BIAS_BUS_HOLD, "input bias bus hold", NULL),
PCONFDUMP(PIN_CONFIG_BIAS_PULL_UP, "input bias pull up", NULL),
PCONFDUMP(PIN_CONFIG_BIAS_PULL_DOWN, "input bias pull down", NULL),
PCONFDUMP(PIN_CONFIG_BIAS_PULL_PIN_DEFAULT,
"input bias pull to pin specific state", NULL),
PCONFDUMP(PIN_CONFIG_DRIVE_PUSH_PULL, "output drive push pull", NULL),
PCONFDUMP(PIN_CONFIG_DRIVE_OPEN_DRAIN, "output drive open drain", NULL),
PCONFDUMP(PIN_CONFIG_DRIVE_OPEN_SOURCE, "output drive open source", NULL),
......
......@@ -40,6 +40,10 @@
* @PIN_CONFIG_BIAS_PULL_DOWN: the pin will be pulled down (usually with high
* impedance to GROUND). If the argument is != 0 pull-down is enabled,
* if it is 0, pull-down is disabled.
* @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based
* on embedded knowledge of the controller, like current mux function.
* If the argument is != 0 pull up/down is enabled, if it is 0,
* the pull is disabled.
* @PIN_CONFIG_DRIVE_PUSH_PULL: the pin will be driven actively high and
* low, this is the most typical case and is typically achieved with two
* active transistors on the output. Setting this config will enable
......@@ -86,6 +90,7 @@ enum pin_config_param {
PIN_CONFIG_BIAS_BUS_HOLD,
PIN_CONFIG_BIAS_PULL_UP,
PIN_CONFIG_BIAS_PULL_DOWN,
PIN_CONFIG_BIAS_PULL_PIN_DEFAULT,
PIN_CONFIG_DRIVE_PUSH_PULL,
PIN_CONFIG_DRIVE_OPEN_DRAIN,
PIN_CONFIG_DRIVE_OPEN_SOURCE,
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment