Commit 6e54d8d2 authored by Laurent Pinchart's avatar Laurent Pinchart Committed by Simon Horman

sh-pfc: Move driver from drivers/sh/ to drivers/pinctrl/

Signed-off-by: default avatarLaurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Acked-by: default avatarPaul Mundt <lethal@linux-sh.org>
Acked-by: Linus Walleij's avatarLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: default avatarSimon Horman <horms+renesas@verge.net.au>
parent 56dc04af
......@@ -196,7 +196,7 @@ config PINCTRL_EXYNOS5440
select PINCONF
source "drivers/pinctrl/mvebu/Kconfig"
source "drivers/pinctrl/sh-pfc/Kconfig"
source "drivers/pinctrl/spear/Kconfig"
config PINCTRL_XWAY
......
......@@ -42,4 +42,6 @@ obj-$(CONFIG_PINCTRL_XWAY) += pinctrl-xway.o
obj-$(CONFIG_PINCTRL_LANTIQ) += pinctrl-lantiq.o
obj-$(CONFIG_PLAT_ORION) += mvebu/
obj-$(CONFIG_ARCH_SHMOBILE) += sh-pfc/
obj-$(CONFIG_SUPERH) += sh-pfc/
obj-$(CONFIG_PLAT_SPEAR) += spear/
comment "Pin function controller options"
#
# Renesas SH and SH Mobile PINCTRL drivers
#
config SH_PFC
if ARCH_SHMOBILE || SUPERH
config PINCTRL_SH_PFC
# XXX move off the gpio dependency
depends on GENERIC_GPIO
select GPIO_SH_PFC if ARCH_REQUIRE_GPIOLIB
select PINCTRL_SH_PFC
select PINCTRL
select PINMUX
select PINCONF
def_bool y
help
This enables pin control drivers for SH and SH Mobile platforms
config GPIO_SH_PFC
bool "SuperH PFC GPIO support"
depends on SH_PFC && GPIOLIB
depends on PINCTRL_SH_PFC && GPIOLIB
help
This enables support for GPIOs within the SoC's pin function
controller.
endif
......@@ -2,4 +2,4 @@ sh-pfc-objs = core.o pinctrl.o
ifeq ($(CONFIG_GPIO_SH_PFC),y)
sh-pfc-objs += gpio.o
endif
obj-y += sh-pfc.o
obj-$(CONFIG_PINCTRL_SH_PFC) += sh-pfc.o
menu "SuperH / SH-Mobile Driver Options"
source "drivers/sh/intc/Kconfig"
source "drivers/sh/pfc/Kconfig"
endmenu
......@@ -5,7 +5,6 @@ obj-y := intc/
obj-$(CONFIG_HAVE_CLK) += clk/
obj-$(CONFIG_MAPLE) += maple/
obj-$(CONFIG_SH_PFC) += pfc/
obj-$(CONFIG_SUPERHYWAY) += superhyway/
obj-y += pm_runtime.o
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment