gpio-omap.txt 1.19 KB
Newer Older
1 2 3 4 5 6 7
OMAP GPIO controller bindings

Required properties:
- compatible:
  - "ti,omap2-gpio" for OMAP2 controllers
  - "ti,omap3-gpio" for OMAP3 controllers
  - "ti,omap4-gpio" for OMAP4 controllers
8
- gpio-controller : Marks the device node as a GPIO controller.
9 10 11
- #gpio-cells : Should be two.
  - first cell is the pin number
  - second cell is used to specify optional parameters (unused)
12
- interrupt-controller: Mark the device node as an interrupt controller.
13 14 15 16 17 18 19 20 21 22
- #interrupt-cells : Should be 2.
  The first cell is the GPIO number.
  The second cell is used to specify flags:
    bits[3:0] trigger type and level flags:
      1 = low-to-high edge triggered.
      2 = high-to-low edge triggered.
      4 = active high level-sensitive.
      8 = active low level-sensitive.

OMAP specific properties:
23 24 25 26 27
- ti,hwmods:		Name of the hwmod associated to the GPIO:
			"gpio<X>", <X> being the 1-based instance number
			from the HW spec.
- ti,gpio-always-on: 	Indicates if a GPIO bank is always powered and
			so will never lose its logic state.
28 29 30 31 32 33 34 35


Example:

gpio4: gpio4 {
    compatible = "ti,omap4-gpio";
    ti,hwmods = "gpio4";
    gpio-controller;
36
    #gpio-cells = <2>;
37
    interrupt-controller;
38
    #interrupt-cells = <2>;
39
};