-
qcom-drivers-for-5.1028993472 · ·
Qualcomm driver updates for v5.10 Replace the busy wait for free tcs slots in the RPMh driver with a sleeping wait and use memory barriers when writing the command registers. Add a bunch of SoC ids to the socinfo driver, fix an erro printin the apr driver and migrate llcc to devm_platform_ioremap_resource_byname().
-
qcom-arm64-defconfig-for-5.10e38175f6 · ·
Qualcomm ARM64defconfig updates for v5.10 Enable Qualcomm related drivers for Lontium LT9611 HDMI bridge, SNPS high-speed USB PHY, various Interconnect providers, GPU clock controllers for SM8150 and SM8250 and audio driver for MSM8996 and APQ8016. Then enable ACM and FTDI host drivers, which are useful when working with various development boards using ARM64 hosts.
-
qcom-arm64-fixes-for-5.922f5adc7 · ·
Qualcomm ARM64 DT fixes for v5.9 This fixes the OPP table for SDM845 QUP devices to bring back Bluetooth support, disables SMMU on SDM630 to make the devices boot again, disables the eMMC controller on Kitakami to prevent permanent damage and fixes a typo in the pm660.
-
qcom-drivers-fixes-for-5.97a366707 · ·
Qualcomm driver fixes for v5.9 Fix the array type of the domain_list QMI response in PDR.
-
-
-
-
-
qcom-drivers-for-5.9-20fec8617 · ·
Qualcomm driver additional updates for 5.9 This fixes a potential race condition with remoteprocs by not sending acknowledgements until after registered drivers has processed the event. It adds IPQ6018 support to the SMD RPM driver, fixes kerneldoc in the same and converts the related DT binding to YAML. Finally it fixes a compilation warning in the geni serial engine driver when compiled without CONFIG_SERIAL_EARLYCON.
-
qcom-arm64-for-5.9-29d56a1c2 · ·
Qualcomm ARM64 DT additional updates for 5.9 For SC7180 this adds the necessary properties for blowing fuses in qfprom, Coresight fixes, GPU interconnect votes and specifies max speed for USB controller. SM8150 and SM8250 gains Adreno SMMU, the graphics management unit and the GPU nodes, to enable headless GPU usage. SDM845 gains tracing support for deep idle, GPU bus bandwidth scaling and DB845c gains the LT9611 HDMI bridge wired up. MSM8994 gains SMD RPM and SCM support and a new dts for the Sony Xperia Z5. MSM8992 is refactored and modernized and gets support for SCM, SPMI, BLSP2 UART and I2C nodes, PMU, RPM clock controller, PSCI and proper CPU definitions. Support for the Xiaomi Libra and Microsoft Lumia 950 are added.
-
-
qcom-drivers-for-5.903c900b3 · ·
Qualcomm driver updates for v5.9 For RPMh this fixes an issue where ktime was used during suspend, allows the driver to be used on ARM targets and some minor cleanups. It adds support for the latest format version in the socinfo driver and adds identifiers for SM8250 and SDM630. SMD-RPM gains compatibles for MSM8994 and MSM8936 and the Qualcomm SCM gains compatibles MSM8994 and IPQ8074. The GENI core code gains interconnect path voting and performance level support, with subsequent patches integrating this with the SPI, I2C, UART and QSPI drivers. Following this the KGDB support for the GENI serial driver is improved, the performance related to chip-select is improved for SPI and QSPI.