igt@kms_flip@* - incomplete/timeout - Received signal SIGQUIT
Stdout
Using IGT_SRANDOM=1712171255 for randomisation
Opened device: /dev/dri/card0
Using monotonic timestamps
Starting subtest: bo-too-big-interruptible
Starting dynamic subtest: A-eDP1
runner: This test was killed due to exceeding disk usage limit. (Used 10503249 bytes, limit 10485760)
Stderr
Starting subtest: bo-too-big-interruptible
Starting dynamic subtest: A-eDP1
Received signal SIGQUIT.
Stack trace:
#0 [fatal_sig_handler+0x10f]
#1 [killpg+0x40]
#2 [ioctl+0x9]
#3 [drmIoctl+0x30]
#4 [___xe_bo_create+0x8d]
#5 [__xe_bo_create+0x4a]
#6 [xe_bo_create+0x22]
#7 [create_bo_for_fb.constprop.0+0x791]
#8 [igt_create_fb_with_bo_size+0xc0]
#9 [run_test_on_crtc_set+0x329]
#10 [run_test+0x29d]
#11 [__igt_unique____real_main1986+0x663]
#12 [main+0x3a]
#13 [__libc_start_main+0xf3]
#14 [_start+0x2e]
Dmesg
<7> [858.847966] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling AUX_TC1
<6> [858.872199] Console: switching to colour dummy device 80x25
<6> [858.872765] [IGT] kms_flip: executing
<7> [858.916158] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:194:DP-1]
<7> [858.916199] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:194:DP-1]
<7> [858.916395] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling AUX_TC1
<7> [858.922407] xe 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX USBC1/DDI TC1/PHY TC1: DPCD: 12 0a c4 01 00 05 01 83 02 00 00 00 00 00 04
<7> [858.943739] xe 0000:00:02.0: [drm:intel_dp_init_lttpr_and_dprx_caps [xe]] [CONNECTOR:194:DP-1][ENCODER:193:DDI TC1/PHY TC1][DPRX] LTTPR common capabilities: 20 1e 80 aa 04 00 01 03
<7> [858.953458] xe 0000:00:02.0: [drm:intel_dp_init_lttpr_and_dprx_caps [xe]] [CONNECTOR:194:DP-1][ENCODER:193:DDI TC1/PHY TC1][LTTPR 1] PHY capabilities: 04 03 00
<7> [858.957509] xe 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX USBC1/DDI TC1/PHY TC1: DPCD: 12 0a c4 01 00 05 01 83 02 00 00 00 00 00 04
<7> [858.961976] xe 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX USBC1/DDI TC1/PHY TC1: DP branch: OUI 90-cc-24 dev-ID SYNA#" HW-rev 1.0 SW-rev 2.27 quirks 0x0028
<7> [858.969277] xe 0000:00:02.0: [drm:drm_dp_read_downstream_info [drm_display_helper]] AUX USBC1/DDI TC1/PHY TC1: DPCD DFP: 08 08 0d
<7> [858.972920] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [ENCODER:193:DDI TC1/PHY TC1] MST support: port: yes, sink: MST, modparam: yes -> enable: MST
<7> [858.976564] xe 0000:00:02.0: [drm:intel_psr_init_dpcd [xe]] Panel replay is not supported by panel
<7> [858.980491] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] source rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 675000, 810000, 1000000, 2000000
<7> [858.980769] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] sink rates: 162000, 270000
<7> [858.981017] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] common rates: 162000, 270000
<7> [858.981250] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:194:DP-1] disconnected
<7> [858.982004] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:206:DP-2]
<7> [858.982021] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:206:DP-2]
<7> [858.982122] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:206:DP-2] disconnected
<7> [858.982475] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:214:DP-3]
<7> [858.982488] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:214:DP-3]
<7> [858.982583] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:214:DP-3] disconnected
<7> [858.983189] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:227:DP-6]