GLK CI: boot - fail - Link is Down
[ 11.029621] [drm:drm_mode_debug_printmodeline] Modeline "640x480": 60 25175 640 656 752 800 480 490 492 525 0x40 0xa
[ 11.029626] [drm:drm_mode_debug_printmodeline] Modeline "640x480": 60 25175 640 656 752 800 480 490 492 525 0x40 0xa
[ 11.029632] [drm:drm_client_modeset_probe] connector 144 enabled? yes
[ 11.029638] [drm:drm_client_modeset_probe] connector 154 enabled? yes
[ 11.029709] [drm:drm_client_firmware_config.isra.0] Not using firmware configuration
[ 11.029727] [drm:drm_client_modeset_probe] looking for cmdline mode on connector 144
[ 11.029736] [drm:drm_client_modeset_probe] looking for preferred mode on connector 144 0
[ 11.029741] [drm:drm_client_modeset_probe] found mode 1920x1080
[ 11.029745] [drm:drm_client_modeset_probe] looking for cmdline mode on connector 154
[ 11.029750] [drm:drm_client_modeset_probe] looking for preferred mode on connector 154 0
[ 11.029754] [drm:drm_client_modeset_probe] found mode 1920x1080
[ 11.029759] [drm:drm_client_modeset_probe] picking CRTCs for 1920x1080 config
[ 11.029835] [drm:drm_client_modeset_probe] desired mode 1920x1080 set on crtc 68 (0,0)
[ 11.029848] [drm:drm_client_modeset_probe] desired mode 1920x1080 set on crtc 105 (0,0)
[ 11.163438] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port B
[ 11.163834] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port B
[ 11.164135] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port C
[ 11.164426] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port C
[ 11.164745] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port D
[ 11.165037] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port D
[ 11.165328] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port D
[ 11.190319] input: HDA Intel PCH Mic as /devices/pci0000:00/0000:00:0e.0/sound/card0/input5
[ 11.193109] input: HDA Intel PCH Line Out as /devices/pci0000:00/0000:00:0e.0/sound/card0/input6
[ 11.193904] input: HDA Intel PCH Front Headphone as /devices/pci0000:00/0000:00:0e.0/sound/card0/input7
[ 11.195524] input: HDA Intel PCH HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:0e.0/sound/card0/input8
[ 11.196884] input: HDA Intel PCH HDMI/DP,pcm=7 as /devices/pci0000:00/0000:00:0e.0/sound/card0/input9
[ 11.199293] input: HDA Intel PCH HDMI/DP,pcm=8 as /devices/pci0000:00/0000:00:0e.0/sound/card0/input10
[ 14.041563] Generic FE-GE Realtek PHY r8169-0-200:00: attached PHY driver (mii_bus:phy_addr=r8169-0-200:00, irq=MAC)
[ 14.204319] r8169 0000:02:00.0 enp2s0: Link is Down
[ 14.792238] i915 0000:00:02.0: [drm:intel_modeset_calc_cdclk [i915]] New cdclk calculated to be logical 316800 kHz, actual 316800 kHz
[ 14.792742] i915 0000:00:02.0: [drm:intel_modeset_calc_cdclk [i915]] New voltage level calculated to be logical 13, actual 13
[ 14.793348] i915 0000:00:02.0: [drm:intel_modeset_verify_disabled [i915]] [ENCODER:143:DDI B/PHY B]
[ 14.793913] i915 0000:00:02.0: [drm:intel_modeset_verify_disabled [i915]] [ENCODER:153:DDI C/PHY C]
[ 14.794285] i915 0000:00:02.0: [drm:verify_single_dpll_state.isra.0 [i915]] PORT PLL A
[ 14.794767] i915 0000:00:02.0: [drm:verify_single_dpll_state.isra.0 [i915]] PORT PLL B
[ 14.795205] i915 0000:00:02.0: [drm:verify_single_dpll_state.isra.0 [i915]] PORT PLL C
[ 17.254003] r8169 0000:02:00.0 enp2s0: Link is Up - 1Gbps/Full - flow control off
[ 17.254122] IPv6: ADDRCONF(NETDEV_CHANGE): enp2s0: link becomes ready
[ 0.000000] microcode: microcode updated early to revision 0x3c, date = 2022-03-23